The most accurate way to get the most from your MOC "Rain" is temporarily remove the shower head, they already have. Place a bucket under the hose, then on the water for 1 minute. When the cube is how it is too small, just run the water for 30 seconds and double the amount going out.
Even easier would be to measure the tub spout. This figure is close to predict the maximum flow shower.
I saw that the showers 8, 10 and 14 GPM at 45 psi, so I think it should work for you. Of course, these rains are not "legally" in the United States because it is the flow of water, but hey, there are more than properly cleaned?
9gpm and flows through the pipes is nothing 1/2in. Pressure drop is not just psi. But it would be very mad 9gpm on the hot water tank and water in general.
3 comments:
The most accurate way to get the most from your MOC "Rain" is temporarily remove the shower head, they already have. Place a bucket under the hose, then on the water for 1 minute. When the cube is how it is too small, just run the water for 30 seconds and double the amount going out.
Even easier would be to measure the tub spout. This figure is close to predict the maximum flow shower.
I saw that the showers 8, 10 and 14 GPM at 45 psi, so I think it should work for you. Of course, these rains are not "legally" in the United States because it is the flow of water, but hey, there are more than properly cleaned?
Good luck.
9gpm and flows through the pipes is nothing 1/2in. Pressure drop is not just psi.
But it would be very mad 9gpm on the hot water tank and water in general.
Post a Comment